BASIC ENGINE
1
10
9
| 2 | |
8 |
| |
7 | 3 | |
6 | ||
|
5 4
Figure 3. Robin Engine Components
The engine (Figure 3) must be checked for proper lubrication and fi lled with fuel prior to operation. Refer to the manufacturer's engine manual for instructions and details of operation and servicing.
1.Fuel Filler Cap — Remove this cap to add unleaded gasoline to the fuel tank. Make sure cap is tightened securely. DO NOT over fi ll.
DANGER
Adding fuel to the tank should be done only when the engine is stopped and has had an opportunity to cool down. In the event of a fuel spill, DO NOT attempt to start the engine until the fuel residue has
been completely wiped up and the area surrounding the engine is dry.
2.Throttle Lever — Used to adjust engine RPM speed (lever advanced forward - SLOW, lever back toward operator - FAST).
3.Engine ON/OFF Switch — ON position permits engine starting, OFF position stops engine operations.
4.Recoil Starter (pull rope) —
5.Fuel Valve Lever — OPEN to let fuel fl ow, CLOSE to stop the fl ow of fuel.
6.Choke Lever — Used in the starting of a cold engine, or in cold weather conditions. The choke enriches the fuel mixture.
7.Air Cleaner — Prevents dirt and other debris from entering the fuel system. Remove
NOTICE
Operating the engine without an air filter, with a damaged air fi lter, or a fi lter in need of replacement will allow dirt to enter the engine, causing rapid engine wear.
8.Spark Plug — Provides spark to the ignition system. Set spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch). Clean spark plug once a week.
9.Muffler — Used to reduce noise and emissions.
WARNING
Engine components can generate extreme heat. To prevent burns, DO NOT touch these areas while the engine is running or immediately after operating. NEVER operate the engine with the muffler removed.
10.Fuel Tank — Holds unleaded gasoline. For additional information refer to engine owner's manual.
PAGE 14 — QP2E CENTRIFUGAL PUMP • OPERATION AND PARTS MANUAL — REV. #0 (02/12/09)