REMOTE CONTROL
OPERATION
The wireless remote control gives the home- owner the ability to operate their ductless sys- tem at the touch of a button. The indoor unit and remote control send information back and forth continuously. The remote control must be placed on a table or other surface in direct line of sight with the indoor unit infrared receiver. The remote control should not be placed in a drawer. Make sure that there are no obstruc- tions between the indoor unit receiver and the remote control. Make sure you do not throw nor drop the remote control. The remote should never come in contact with liquids and should not be left in direct contact with the sun or any place that's very hot.
POWER BUTTON
When this button is pressed, the system will turn on. When pressed the second time, the
system will turn off. When turning the system on or off, the Timer and Sleep functions (if activated) will be canceled; however the clock time will be continue to operate even when the system is off.
MODE BUTTON
Press this button to select system operating modes. AUTO mode is the default setting when the system is turn on. As MODE button is pressed,
COOL, DRY, FAN and HEAT (for heat pump only) modes can be selected in this order. The selected mode is displayed on both the remote control and the indoor unit's cover panel displays. When AUTO
mode is selected, the temperature will not be displayed. When in COOL mode, the default setpoint temperature is 77°F (25°C). When in HEAT mode, the default setpoint temperature is 69°F (21°C).
+/- BUTTONS
Use plus (+) and minus
NOTICE
The temperature cannot be adjusted when the system is in AUTO mode.
FAN BUTTON
Press FAN button to select fan speed. AUTO fan is the default setting. In AUTO fan mode, the indoor fan speed
is determined by the indoor ambient temperature. Press FAN button to
select the desired fan setting in the following order AUTO, Low Speed, Medium Speed and High Speed. The fan speed selection is displayed at the top of the remote control display by one of these symbols.
NOTICE
The fan speed is not adjustable in DRY mode operation. The low fan speed is necessary to ensure optimal humidity control.
I FEEL BUTTON
Press the I FEEL button to activate the I FEEL feature. When the I FEEL icon appears, the system will satisfy your cooling or heating (heat pump only) setpoint temperatures where the remote control is located. Press the I FEEL button again to deactivate. When I FEEL function is deactivated, the system will satisfy the cooling and heating (heat pump only) setpoint temperatures where the indoor unit is located. To use the I FEEL mode, the remote control must be placed in direct line of sight with the indoor unit infrared receiver. Make sure that there are no obstructions between the indoor unit receiver and the remote control when I FEEL feature is activated.
SWITCH FROM °C TO °F
With system OFF, press MODE and
CLOCK BUTTON
Press the CLOCK button to adjust the time displayed on the remote
control. The clock icon 
will flash. Press the
Press the
This function allows removal of excess moisture from the indoor unit coil after in order to prevent possible mold or bacterial growth. When the 
is displayed when this feature is turned on. To deactivate, press
LOUVER SETTING BUTTON
Press this button to set the position of the indoor unit swing louver. When this feature
is turned on, icon | appears on the remote | OFF |
control display. Continue to press the LOU- |
| |
VER icon to select the desired swing angle as shown in the following sequence. When activated, the louver will start swinging right to left.
SLEEP BUTTON
Use the SLEEP button to activate or cancel the sleep function. To acti- vate sleep function, press SLEEP button and the sleep icon should appear on the remote control display. Press SLEEP button to cancel sleep function and the sleep icon on the remote control should disap- pear.
In cooling mode, SLEEP function increases temperature by 2°F per hour over a two hour period from the time sleep function is activated. In heating mode, SLEEP function decreases temperature
Sleep function is defaulted to off when the system is turned on. If the system is turned off the Sleep function is automatically disabled.
NOTICE
The sleep function is not available in AUTO or FAN modes.
Johnson Controls Unitary Products | 5 |