GE ABN12 operating instructions For Propergrounding, Groundthe outlet throughthe house wiring

●

properly installed in accordance with the Installation Instructions before it is used.

●Repair or replace immediately all electric semice cords that have become frayed or othemvise damaged.

and unplug your air conditioner	3
	;
before making any repairs.	j
	;
	.,
NOTE’We strongly recommend
that any semicing be performed by	~
a qualified individual.	$.
	:
	}
	$
	.

.,*.*k-,-...: . ,. - ,, ,.-’*,W6 t“,.- , ..?. $.’ >..- . . ..-%W*... :. ....*,, .-J .,,&.! % ~ ., . + l.-s+ ..,.. ,..,, <**,., , ,.<,s. , “.*>.~,,+,++..r ..-%.., ,-.> ., . ., .,, /- ,,.. — .*..* ~..*.w.,.-,.,,* .,* *...**.—

If an extension cord is required to reach the nearest wall receptacle, use only a UL-listed, 3-wire, grounded, 14 gauge, 15A, 125V appliance extension cord. For models with nameplate ratings greater than 12 amperes, do not use an extension cord.

A CAUTION:

DO NOT use an extension cord with any of the 20&Z30-volt models.

. 0

. o~ /0

“Q “--l 67

7on

J

\6P

T

This is a temporary method. UL-listed adapters are avail- able at most hardware stores.

Because most 2-prong outlets are not grounded, we strongly advise against using an adapter plug.

However, a temporary connection may be made where local codes permit and if the 2-prong wall out- let is properly grounded.

When you plug the adapter in, make sure the larger prong goes into the larger slot to provide the proper polarity for the power cord.

FOR PROPERGROUNDING:

1 Screw the adapter to the outlet, using the outlet cover screw.

2Groundthe outlet throughthe house wiring.

When disconnecting the power cord from the adapter, hold the adapter close to the outlet while pulling the plug out. If this is not done, the grounding connector is likely to break with repeated use.

If the grounding connector breaks, DO NOT USE the air conditioner until a proper ground has again been made.

SAVE T~SE INSTR UCTIONS

3