
Installation of the Drain Tube
Fix the drain tube as shown in the figure.
Installation of the Drain Pan
The procedure for installing the drain pan should be determined by the condition of the installing area.
◆In the case of an area where the drain pan can not be directly installed on the rear side of the unit after installing the air conditioner.
Example: High storage
1Hold the handle of the air filter, pull it slightly forward, and then pull it out to the right side.
2Remove the screw.
3Disassemble the front grille.
☛Applying excessive force to disassemble the front grille may cause damage to the tab ; be sure not to use excessive force.
4Remove two screws on the lower, right and left sides of the unit.
5Remove the chassis from the cabinet.
6Remove the rubber cap inserted into the basepan.
7Fix the drain pan as shown in the figure, and then connect the drain hose. (You can use any
8Install the cabinet at the specified area after installing the drain pan, and then
◆In the case of an area where the drain pan can be directly installed on the rear side of the unit after installing the air conditioner.
1Follow steps 6 and 7 only
Rear
Rubber cap
Gasket
Drain Tube
Screws(2EA) |
Screw |
Front grille |
| Drain Pan |
Rear |
|
Rubber cap |
|
Drain Hose | Screw |
Drain Pan and Hose in Place |