Step 20
Install Lid
You will need: lid, two hinge pins and two hair pin cotters.
Set the lid in place. Align the hinges at the rear of the barbecue. Insert hinge pins from the outside. Insert hair pin cotters into the small holes in the hinge pins. Figure 32.
Hair pin cotter
Hinge pin
Step 21
Add tool holders, control panel and burner control knobs
You will need: three tool holders, control panel, two Phillips screws/washers, a Phillips screwdriver, and three burner control knobs.
Hook the tool holders over the frame rail and snap down into place. Figure 33.
Set the control panel in place over both frame braces. (Hold the Crossover Ignition button up while setting the control panel in place.) Line up the holes in the control panel with the holes in the inserts in the frame brace. Insert screws and tighten with a Phillips screwdriver until snug. Do not overtighten. Figure 33 (a).
Push on the burner control knobs. Figure 33 (b).
Crossover
Insert in
frame brace
(a)
Figure 32
Ignition Button
Control panel
Phillips screws/
washers
Tool holders | (b) |
Figure 33
25
