Securing an MVP Panel to an MVP-KS
1.Place the MVP face down and locate the
These pins are inserted into the respective MVP alignment guide insertion holes (located along the underside of the MVP and at either sides of the connector strip).
2.Grasp both sides of the kickstand and insert the alignment guide pins into the insertion holes on the bottom of the MVP (FIG. 1).
3.Maintain a kickstand connection to the bottom of the MVP panel (FIG. 2).
alignment pins
FIG. 2 Installing an MVP-KS
4.Press down on the AMX logo to insert the retractable latch into the opening (just above the MVP metallic plate). Upon proper connection, you should hear a click when the latch grabs onto the metallic plate.
5.Extend the
To avoid potential damage to the panel, make sure the kickstand is installed properly before use.
Removing an MVP Panel from an MVP-KS
1.Place the MVP panel face down, and pull upwards on the MVP latch release lever, located below the kickstand’s AMX logo (FIG. 3).
MVP latch release lever
FIG. 3 Releasing the MVP- from the MVP-KS
2.Pull off the MVP-KS from the back of the MVP panel.
2 |