Pelco C1666M-A (4/06) manual Setting the DIP Switches

Page 9

SETTING THE DIP SWITCHES

You can override the adaptive technology by manually adjusting switches 1 through 4 on the DIP Switch. The factory default switch positions are shown in Figure 3. Switches 1 through 4 are set to AUTO and Switch 5 is set to H MODE (high mode).

Figure 3. Default Switch Positions

If you want to transmit video over 4,000 feet (1,219 meters) of UTP cable, set switch 1 to 4K. Set switch 2 to 3K if you want a distance of 3,000 feet (914 meters), switch 3 to 2K if you want a distance of 2,000 feet (610 meters), and switch 4 to 1K if you want a distance of 1,000 feet (305 meters). You can set only one distance at a time.

With switch 5 you can select H (high) or L (low). High mode is the default position and is used when video is 1Vp-p. Low mode is used when video is less than 1Vp-p.

C1666M-A (4/06)

9

Image 9
Contents TW3001AR Active Receiver Page Important Safety Instructions Radio and Television Interference Regulatory NoticesDescription Parts of the Receiver Mounting InstallationUsing a Wall Clip Setting the DIP Switches Applications Shows a TW3001AR connected to a UTP Camclosure Shows a TW3001AR connected to a UTP fixed camera TW3001AR Connected to a Spectra Dome TW3001AR Connected to a Single Passive Transceiver Shows a TW3001AR connected to a TW3032P passive transceiver TW3001AR Connected to a 4-Channel Passive Transceiver Electrical SpecificationsC1666M-A 4/06 Product Warranty and Return Information ISO9001