Panasonic SC-HT895 manual Attaching to a wall, Fitting speaker stands not included, Speakers

∫HT895PreventingEn.bookPage7Friday,the speakersApril21,20064:17PMfrom falling

≥You will need to obtain the appropriate screw eyes to match the walls or pillars to which they are going to be fastened.

≥Co sult a qu lified housing cont actor concerning the appropriate procedure when attaching to a concrete wall or a surface that may not have strong enough support. Improper attachment may result in damage to the wall or speakers.

String (not included) Thread from the wall to the speaker and tie tightly.

		Screw eye		Approx.
Rear of the s	peaker	(not included)	Wall	150 mm

Simple Setup

Speaker installation options

∫Attaching to a wall

You can attach all of the speakers (except subwoofer) to a wall.

≥The wall or pillar on which the speakers are to be attached should be capable of supporting over 10 kg per screw. Consult a qualified building contractor when attaching the speakers to a wall. Improper attachment may result in damage to the wall and speakers.

≥When mounting the front speakers or surround speakers

([Australia[and[N.Z.] front speakers only) to a wall, we recommend using a string (not included) to prevent it from falling.

4 Screws	4 Cover plates
[Australia[and[N.Z.]	[Australia[and[N.Z.]
2 Screws	2 Cover plates

Center speaker

200 mm

e.g.	In this position, the
	speaker will likely
	fall if moved to the
	left or right.

Surround speaker [Australia[and[N.Z.]

Move the speaker so that the screw is in this position.

the speakers

Preparation for front and surround speakers ([Australia[and[N.Z.] front speakers only)

1 Remove the speaker cable from the stand.

Release the cable from the groove.

2Connect the cable (➜ page 6).

1 Attach the cover plate to the front speaker or surround speaker. ([Australia[and[N.Z.] front speaker only)

Cover plate Screw

Tighten securely.

2Drive a screw (not included) into the wall.

‰4.0 mm	‰7.5 to 9.5 mm
Wall or pillar	5.0 to 7.0 mm

3Fit the speaker securely onto the screw(s) with the hole(s).

Front and surround speaker Front speaker [Australia[and[N.Z.] 106 mm

340 mm

Reattaching the speaker cable to the stand

1Remove the eight screws from the stand, and remove the speaker net.

Screw

2 Position the cable.

Approx.15 cm

Press the cable into the groove.

Cable

3 Attach the speaker net with the screws.

∫Fitting speaker stands (not included)

\Southeast\Asia,\Thailand,[the\Middle\East,\South\Africa,]

[Saudi\Arabia\and\Kuwait\

(For center speaker)

[Australia[and[N.Z.]

(For surround speakers and center speaker)

Ensure the stands meet these conditions before purchasing them. Note the diameter and length of the screws and the distance between screws as shown in the diagram.

≥The stands must be able to support over 10 kg.

≥The stands must be stable even if the speakers are in a high position.

e.g. Center speaker

Metal screw holes

For attaching to speaker stands

5 mm, pitch 0.8 mm

Plate thickness plus
7 mm to 10 mm	60 mm

Speaker stand

(not included)

Assembling

RQT8607

7