Smeg ML60 manual Instructions for the installer, Installing the Parts, Installing the tap

Page 3

Instructions for the installer

2.INSTALLING THE PARTS

2.1Installing the tap

Prepare the area where the tap is to be installed then proceed as follows:

•Insert the tap (2) into the housing hole (1), making sure that the o- ring seal (4) is in place between the tap and the sink contact surface.

•Underneath the sink, insert the plastic below-sink reinforcement (5), together with the rubber seal (6).

•Fix the tap in place by inserting the mounting flange (7) and the hold-down nut (8); check that the tap is in the correct position in relation to the sink and tighten the nut using a suitable spanner or similar tool.

	2
	4	1
	6	1
	6
	5
	7
	8

Image 3

Contents Contents Safety and USE Notices Instructions for safety and useInstructions for the installer Installing the PartsInstalling the tap Installation diagram for sink parts Overflow drain Positioning Built-in installationConnection to the water distribution network Installation on a trolleyTo the network Water DrainTo a tank For dispersion away from the sinkGeneral instructions and advice Instructions for the userUSE of the Sink Description of the Controls Cleaning stainless steel Cleaning and MaintenanceInspection and cleaning of the drain