Pelican PSE2000 owner manual PSE1800-2000Rev M, Bypass Valve Fittings

Pelican PSE1800/PSE2000 Premium Whole House Water Filter	PSE1800-2000 Rev M
& Salt Free Water Softener/Conditioner Combo	Page 11

Whole House Salt Free Water Softener/Conditioner Tank Installation

1. Level the Pelican Salt Free Water Softener/Conditioner.

Notice:

If the tank is not level, lift the tank straight up 6 inches and tap it on the ground until the tank stands vertical. The bottom of the tank is round and the boot allows the tank to stand upright.

Wall

IN

Pre-Filter

OUT

	Wall
	PVC Fitting*
Incoming	Outgoing
Water	Water
Supply	To House

1" NPT Assembly

Whole House	Salt Free Water	*Customer supplied,
Water Filter		choose appropriate
	Softener/Conditioner	connection

Figure 8

2.Determine the size and material of your incoming water supply line from the Whole House Water Filter and choose the appropriate fittings required to connect it to the Bypass Valve.

CAUTION:

Do not over-tighten any of the fittings during installation.

Table 3: Bypass Valve Fittings

Note: The fitting below is designed with a ¼" give to allow for proper pipe alignment. It will not leak and is intended to have some flexibility.

Part	Description	Qty.
	1" Plastic Male NPT Assembly:	1
	V3007-04 WS1 Fitting 1" Plastic Male	bag
	NPT Assembly (2): O-Rings (2), Split
	Rings (2), and Connectors (2)

3.Install the fitting onto the upflow and downflow inlet sides of the Bypass Valve. Follow the diagrams supplied with the fitting.

4.Connect the incoming water supply from the Pre-Filter System to the fitting on the upflow inlet side of the Bypass Valve.

5.Connect the outgoing water supply to the downflow inlet side of the Bypass Valve.

© 2013 Enviro Water Solutions, Inc.	www.pelicanwater.com
3060 Performance Circle, Suite 2, DeLand, FL 32724	(877) 842-1635