Pelican PSE2000 owner manual Pre-FilterAssembly, Pre-FilterInstallation, PSE1800-2000Rev M

Pelican PSE1800/PSE2000 Premium Whole House Water Filter	PSE1800-2000 Rev M
& Salt Free Water Softener/Conditioner Combo	Page 9

Installation

Pre-Filter Assembly

Pre-Filter Cover Sediment Filter

O-Ring

Blue Pre-Filter Housing

Stand Pipe

Figure 5

1.Unscrew the cover from the Blue Pre-Filter Housing.

2.Remove the plastic covering from the Sediment Filter.

3.Place the Sediment Filter onto the Stand Pipe in the Blue Pre-Filter Housing.

4.Screw the cover onto the Blue Pre-Filter Housing until hand-tight.

Pre-Filter Installation

Mounting

Bracket

Inlet Water

Supply

Top View Pre-Filter

Blue Pre-Filter Housing

Figure 6

1.Shut off the water.

2.Attach the Mounting Bracket to the wall using the supplied Phillips Head Screws and Washers.

3.Attach the Pre-Filter System to the Mounting Bracket using the supplied Bolt Head Screws.

4.Lube the o-ring with clean silicone grease before attaching the cover onto the housing.

5.Tighten the Blue Pre-Filter Housing using the supplied Pre-Filter Wrench (counter clockwise).

6.Determine the size of your inlet water supply line. PVC Reducers may be needed to fit the 1” Pre- Filter System.

Notice:

The Pre-Filter Housing comes with a 1” threaded female inlet/outlet and will require additional fittings to adapt to your plumbing. A shut-off valve is recommended prior to the Pre-Filter System.

© 2013 Enviro Water Solutions, Inc.	www.pelicanwater.com
3060 Performance Circle, Suite 2, DeLand, FL 32724	(877) 842-1635