2 MAKE WATER SUPPLY CONNECTIONS
Turn off hot and cold water supplies before beginning.
Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply (Marked with a Red Stripe) to Hot and right supply (Marked with Blue Stripe) to Cold wall supply. Use adjustable wrench to tighten connections. Do not over tighten.
Faucet supplies are
B L U E
R E DS T R I P E S T R I P E
2
Note: If additional supply length is required, installer must purchase additional parts separately.
1 COLD
HOT
Important: If SUPPLY HOSES (1, 2) are too long, loop as illustrated to avoid kinking.
3 TEST INSTALLED FAUCET
Move HANDLE (1) into "off" position.
Unthread SPRAY END (2) from HOSE END (3).
Turn on water supplies and check connections for leaks.
Operate HANDLE (1) on and off, hot and cold to flush water lines thoroughly. Replace SPRAY END (2).
Check all drain connections for leaks. 
Move HANDLE (1) to "off" position.
3
2 |
| 1 |
|
HOT & COLD SUPPLIES