INSTALLATION INSTRUCTIONS
CADET 1.6 GPF TWO-PIECE PRESSURE- ASSISTED TOILETS
-Model 2333 Elongated
-Model 2366 Round Front
-Model 2377 Elongated -
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.
!CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
NOTE: For proper operation these products require a minimum of 20 psi line pressure
RECOMMENDED TOOLS AND MATERIALS
Putty Knife | Regular Screwdriver | Adjustable Wrench | Sealant | Tape Measure |
Hacksaw | Wax Ring/Gasket | Flexible Supply Tube | Closet Bolts | Carpenters Level |
1REMOVE OLD TOILET
a.Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.
b.Disconnect and remove supply line. NOTE: If replacing valve, first shut off main water supply!
c.Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.
d.Remove closet bolts from flange and clean away old wax, putty, etc. from base area. NOTE: Mounting surface must be clean and level before new toilet is installed!
O R F U T U R E U S E
2
FINISHED WALL
31 (787mm)
REF.
29 (737mm) REF.
(495mm)
29
(737mm)
OR
(800mm)
ADA HEIGHT
SUPPLY
AS
REQ'D
*203mm(8)
3
CLOSET FLANGE
305mm
(12)
CLOSET BOLTS 
S A V E F
305mm |
| FINISHED |
(12) |
| FLOOR |
DIMENSIONS (Nominal) NOTE: Distance from wall to closet flange centerline
INSTALL CLOSET BOLTS
Install closet bolts in flange channel, turn 90° , and slide into place 6" (152 mm) apart and parallel to wall.
Saniwares
P r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A m e r i c a n S t a n d a r d I n c . © A m e r i c a n S t a n d a r d I n c . 2 0 0 4
730479 - 100 Rev . A