American Standard 2555.801 Attach Cable Connector, Check Operation of POP-UP, Cold, Hot

7ATTACH CABLE CONNECTOR

Thread CABLE CONNECTOR (1) clockwise onto DRAIN BODY CONNECTION (2) and hand tighten. Fig. A.

Your new POP-UP DRAIN installation is now complete. Fig. B.

Note: Tailpeice on pop-up drain is 1-1/4” O.D.

Fig. B.

Fig. A.

1

2

Fig. B.

1-1/4” O.D.

8 CHECK OPERATION OF POP-UP
Operate LIFT KNOB (1) to verify that STOPPER (2) opens and	1
closes.

Note: If STOPPER (2) does not open and close properly then refer to the “troubleshooting section” of these instructions.

2

9MAKE WATER SUPPLY AND WASTE CONNECTIONS

NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS NOT INCLUDED

AND MUST BE PURCHASED SEPARATELY.

Thread TEE BODY (4) to SPOUT SHANK (5).

Thread HOSE CONNECTOR (6, 6A) to VALVE CONNECTIONS (7, 7A).

Connect water supply to VALVE BODIES (1,1A) with 1/2" IPS FLEXIBLE
SUPPLIES (2) or 3/8" O.D. BULL-NOSE RISERS (3). Use
adjustable wrench to tighten connections. Do not over tighten.
Be careful not to kink copper supply when bending. Use tubing				1A
cutter to cut to proper length.
Connect HOT water supply to inlet of left SHANK and COLD			5	7A
				6A
water supply to right SHANK using sealant, appropriate
connectors, and COUPLING NUTS.				COUPLING
Connect 1-1/4” O.D. tailpiece on POP-UP DRAIN to				NUT
	1
waste outlet.		7	4
				3
1/2" PIPE THREAD		6
			3/8 O.D.
			BULL-NOSE
	2		RISERS	COMPRESSION
		FLEXIBLE		NUT
			COLD	FERRULE
		SUPPLIES
HOT		3/8 COMPRESSION
		CONNECTION

M968787 Rev. 1 . 3

3