3 MAKE WATER SUPPLY CONNECTIONS
NOTE: FLEXIBLE SUPPLIES OR
Connect water supply to FAUCET SHANKS (1) with 1/2" IPS FLEXIBLE SUPPLIES (2) or 3/8" O.D.
Use adjustable wrench to tighten connections. Do not over tighten. Be careful not to kink copper supply when bending. Use tubing cutter to cut to proper length.
1
1
2
COUPLING NUT
3
FERRULE
4 | TEST INSTALLED FITTING | 5 | SERVICE | STOP | 90˚ |
| |||||
|
| WASHER |
| ||
| With HANDLES (1) in OFF position, turn on WATER |
| To change direction of handle rotation, |
| |
| SUPPLIES (2) and check all connections for leaks. |
|
| ||
|
|
| proceed as follows: |
|
|
| Remove AERATOR (3). |
| Turn valve to OFF position. |
|
|
| Operate both HANDLES to flush water lines thoroughly. |
| Pull out INDEX CAP and remove |
| |
|
| HANDLE SCREW. |
|
| |
| Replace AERATOR (3). |
| Remove SPRING CLIP. |
| SPRING |
|
| Lift STOP WASHER, turn 90˚ and replace. | |||
|
|
| Replace SPRING CLIP. |
| CLIP |
|
|
|
|
| |
|
|
| Replace ADAPTER, HANDLE, SCREW, and INDEX CAP. | ||
|
|
| AERATOR may accumulate dirt causing distorted and | ||
|
|
| reduced water flow. Remove AERATOR and rinse clean. | ||
|
|
| If spout drips, operate handles several times from OFF | ||
|
|
| to ON position. Do not force - handles turn only 90˚. | ||
3
1
1
ALIGN HANDLES
Pull out INDEX CAP (1) and remove | 1 | |
2 | ||
HANDLE SCREW (2), HANDLE (3) | ||
and ADAPTER (4). | 3 | |
Push ADAPTER (4) on VALVE STEM (5). |
| |
Find correct position of HANDLE (3) by |
| |
adjusting male teeth on ADAPTER (4) to | 4 | |
female teeth on HANDLE (3). | ||
Replace HANDLE SCREW (2) and push | 5 | |
in INDEX CAP (1). |
|
2
6 CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.
M968935 Rev . 1 . 1