2 POP-UP DRAIN
Remove CLEAR PLASTIC COVER (1).
Remove CARDBOARD SPACER (2) from under DRAIN
Tighten TAILPIECE (4) on DRAIN BODY before installing DRAIN BODY. Fig. B.
Fig. A.
1
3
2
Fig. B.
DRAIN
BODY
4
3 REMOVE FLANGE
Thread FLANGE (1)
body. Fig. A.
Thread LOCKNUT (3)
Fig. A.
1
2
Fig. B.
4
3
4 | INSTALL DRAIN FROM |
BELOW FIXTURE |
From under side of SINK
REAR OF SINK
5 TIGHTEN LOCKNUT
Tighten LOCKNUT (1) firmly with Adjustable
install DRAIN BODY (1) up through drain outlet.
Note: No plumber’s putty or caulk is required.
The CABLE ATTACHMENT POINT (2) must face towards the rear of the SINK.
4
3
DRAIN OUTLET
1
Wrench or Channel Locks.
1
Install FOAM GASKET (3) and FLANGE (4) onto drain body from above SINK and tighten FLANGE (4) firmly.
2 |
6 FLANGE GASKET AND POP-UP KNOB
Check DRAIN FLANGE in SINK to ensure that WHITE FOAM GASKET (3) is fully compressed and not visible. Fig. A.
Fig. A.
WHITE FOAM |
|
GASKET | DRAIN |
NOT VISIBLE | FLANGE |
Fig. B. DOWN
1
M968491 Rev . 1 . 2
2