American Standard 6028.201 Test Installed Fitting, Check Drain Connections, Service

10 TEST INSTALLED FITTING

4

With HANDLES (1) in OFF position, turn on WATER

SUPPLIES (2) and check all connections for leaks.

Remove AERATOR (3).

Operate both HANDLES (1) to flush water lines thoroughly.

Replace AERATOR (3).

1

CHECK DRAIN CONNECTIONS

Operate POP-UP KNOB (4) and fill lavatory with water. Check that DRAIN STOPPER (5) makes a good seal and retains water in SINK. If DRAIN STOPPER (5) does not seal properly, please refer to Troubleshooting section in these instructions.

Release POP-UP KNOB (4) down and check all drain connections and "P" trap for leaks.Tighten

if necessary.

5

WASTE

OUTLET

3

2

2 “P” TRAP

11 SERVICE

To change direction of handle rotation, proceed as follows:

1

2

3

Turn valve to OFF position.

Remove IINDEX (1) and HANDLE SCREW (2).

Pull HANDLE (3) off.

Remove ADAPTER (4) and SPRING CLIP (5).

Lift STOP WASHER (6), turn 90˚ and replace.

Replace SPRING CLIP (5).

Replace ADAPTER (4), HANDLE (2), SCREW (2), and INDEX (1).

If spout drips, operate handles several times from OFF to ON position. Do not force - handles turn only 90˚.

90˚ 4

6

5

12 CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.

M968833 REV. 1 . 2

4