Rinnai 26i, HD50i user manual Temperature Controls Information

TEMPERATURE CONTROLS - INFORMATION

Do not push the On/Off button on the					Temperature priority can not be switched
Master controller after transferring priority					to another controller when the water is
of temperature selection to a Secondary					flowing through the water heater.
controller as the system will shut down.
Do Not Turn OFF							500C
the Master
Controller
					Controller 1				Controller 2
					in use				cannot take
									priority
If a temperature higher than 50ºC has					Do not clean the remote control with
been selected on the Master controller					solvents or detergents. Use only a soft
and priority of temperature selection is					damp cloth.
transferred to another controller (or it is
turned off), then back again (or turned on
again), the temperature on the Master
controller will automatically drop to 50ºC.
If the set point is less than 500C it will not
alter. This is a safety feature.
	Master	Another	Master
Controller		Controller	Controller
Depending on the weather conditions					If a temperature higher than 420C has
and the length of the pipe between the					been selected on the Universal control-
heater and the tap in use, there may be a					ler and priority of temperature selection is
variation between the temperature dis-					transferred to another controller (or con-
played at the controller and the tempera-					troller is turned OFF), then back again (or
ture at the tap.					turned ON again), the temperature will
					automatically drop to 420C. If the set
					point is less than 420C it will not alter.
					This is a safety feature.
			480C
					Universal	Another		Universal
					Controller	Controller		Controller
				27