Stovax Gazco Ceremica Log Effect Stove Range Installation, Control Upgrade, Safety Precautions

Page 10

INSTALLATION INSTRUCTIONS

INSTALLATION

IMPORTANT: ENSURE THAT THE APPLIANCE IS CORRECTLY ADJUSTED FOR THE GAS TYPE AND CATEGORY APPLICABLE IN THE COUNTRY OF USE. REFER TO DATABADGE AND TECHNICAL SPECIFICATIONS OF THIS BOOKLET. FOR DETAILS OF CHANGING BETWEEN GAS TYPES REFER TO SECTION 11, REPLACING PARTS.

1.CONTROL UPGRADE

1.1This stove is fitted with a control valve that can be easily upgraded to battery powered remote control. There are two versions of this control which can be obtained through your local Gazco stockist.

1.2This upgrade can be fitted before or after installation but if side clearances are limited then it will be easier to upgrade the stove before installation. Full instructions are included with the kit.

1.3STANDARD REMOTE CONTROL

This remote control can control the gas appliance after the pilot has been lit. It can turn the main burner on and regulate it from low through to high and back again. It can turn the main burner off leaving the pilot burning. GAZCO PART NUMBER 8455.

1.4THERMOSTATIC AND TIMER REMOTE CONTROL

This remote control can control the gas appliance after the pilot has been lit. In "MANUAL MODE" it can be used to turn the main burner on and manually regulate it from low through to high and back again. It can also be used to turn the main burner off leaving the pilot burning. In "AUTO MODE" it will automatically regulate the room temperature. In "TIMER MODE" it will turn the fire on and off according to a pre-set programme and automatically regulate the room temperature during two on periods. GAZCO PART NUMBER 8456.

2.SAFETY PRECAUTIONS

2.1This appliance must be installed in accordance with the rules in force, and used only in a sufficiently ventilated space. Place read these instructions before installation and use of this appliance.

2.2All the instructions must be left intact with the user.

2.3In your own interests and those of safety, this appliance must be installed by a competent person in accordance

with local and national codes of practice. Failure to install the appliance correctly could lead to prosecution.

2.4This appliance is intended for use on a governed gas installation and set to the required pressure.

2.5Keep all plastic bags away from young children.

2.6Do not place any object on or near to the stove. Allow adequate clearance above the stove. See diagram 2 Site Requirements, Appliance Location.

2.7The stove is fitted with the Gazco Flue Sure System, which will act to cut off the gas supply to the appliance in the event of incorrect operation of the flue. If the system acts to shut off the gas supply, this indicates that there is insufficient flue pull. If this occurs a minimum of 10 minutes should be

allowed before trying to relight. Continued operation of this safety device means that there may be a serious problem with the flue system; a qualified gas engineer should inspect this. DO NOT USE THE STOVE UNTIL AN ENGINEER SAYS IT IS SAFE TO DO SO.

2.8The Flue Sure System must not be tampered with. Use only genuine Gazco replacement parts when servicing the system

-refer to Servicing section, Replacing Parts.

3.INSTALLATION OF THE STOVE

FLUE PIPE INSTALLATION

3.1Open the carton and remove accessory carton and stove unit. It will now be necessary to decide upon top or rear flue exit, the stove is factory built for rear flue exit, but it may be changed to top exit by using the following method.

3.1.1Remove the flue spigot from the rear of the stove and replace with the blanking plate from the top of the stove and vice versa.

3.2When installing with a top flue, please note the flue pipe fits through a hole in the top grill, the dimensions are for floor fixing a top flue installation with clearance for side panels.

3.3Position the engine assembly in its intended location and mark the position of the floor fixing holes at the base of each side of the subframe, minimum fixing dimensions to a rear wall are showin in Diagram 3

3.4Remove the assembly and drill the two holes using a No.12 masonry bit. Push the rawl plugs into the holes and place the engine assembly in position. Secure to the floor using the screws provided. Sea Diagram 1.

1

158 mm

AR0631

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Ceramica Log Effect Stove Range Contents Flue Check Pass Fail Appliance Commissioning ChecklistGAS Check General User InstructionsLighting the Stove Upgrading Your Stove Cleaning the FireTurning OFF the Stove Handling & Disposal of Fire CeramicsPossible. See diagram Flame Failure Device Installation DetailsGazco Flue Sure System 10. ‘RUNNING IN’Installation Instructions Technical SpecificationFlue and Chimney Requirements Installation of the GAS SupplySite Requirements Appliance LocationSafety Precautions InstallationControl Upgrade Installation of the Stove Flue Pipe InstallationAR0934 Fuelbed Arrangements Lighting Commissioning CommissioningServicing Requirements Servicing / Fault Finding ChartsServicing Instructions Ignition Functional CheckPilot will not Stay LIT or Fire Goes OUT in USE Flame Failure Functional CheckNo Spark Replacing Parts Main BurnerPilot Unit Piezo Magnetic Safety ValveIgnition Lead GAS ValveMain Injector Primary Aeration Plate Changing Between GAS TypesLPG Short Spares ListTTB Service Records Member of the Stovax Group

Gazco Ceremica Log Effect Stove Range specifications

The Stovax Gazco Ceramica Log Effect Stove Range is a perfect blend of modern design and traditional aesthetics, making it an ideal choice for homeowners looking to add warmth and charm to their living spaces. This range features a stunning log effect that mimics the look of real wood burning, providing the cozy ambiance of a traditional fireplace without the hassle of wood maintenance.

One of the standout features of the Ceramica Log Effect Stove is its advanced technology. The stove utilizes a highly efficient combustion system that maximizes heat output while minimizing emissions. This means that not only does it provide a welcoming warmth, but it also adheres to strict environmental standards, making it an eco-friendly heating choice. The range is designed to be compatible with various fuel types, including gas and electric, which allows for versatility in installation and operation.

The Ceramica range is characterized by its stylish ceramic exterior, available in a variety of colors and finishes. This modern design allows it to fit seamlessly into any home decor, from contemporary to rustic. The ceramic material not only enhances the visual appeal but also helps retain heat for extended periods, ensuring a lasting warmth throughout the room.

Moreover, the Ceramica Log Effect Stove is equipped with a powerful heat distribution system. This guarantees efficient warmth throughout the space, eliminating cold spots and providing a comfortable environment. The stove’s large viewing window offers an unobstructed view of the realistic flame effect, creating an inviting and soothing atmosphere.

User-friendliness is another key aspect of this stove range. It features intuitive controls and convenient design elements, allowing for easy operation and maintenance. The stove can be adjusted to suit individual preferences, and its automatic ignition system ensures a hassle-free start every time.

In conclusion, the Stovax Gazco Ceramica Log Effect Stove Range combines aesthetic elegance with cutting-edge technology. Its efficient heat output, eco-friendly operation, and distinctive design make it an outstanding choice for anyone looking to elevate their home’s heating solution while enhancing its visual charm. With its myriad of features and style, the Ceramica Log Effect Stove stands as a testament to quality and innovation in modern heating design.
Top Page Image Contents