Attaching the RTM-C to the Suspension Pole

RTM-C

Attaching the RTM-C to the Suspension Pole

Once the mounting configuration has been determined and installed, the RTM-C may be attached.

NOTE: Depending on the installation configuration, a 1-1/2” NPT must be installed prior to installing the RTM-C.

NOTE: It is recommended that two people install the RTM-C. While one person attaches the RTM-C onto the suspension pipe, the other person must hold the ladder.

Threaded Pipe

Cable

Management

Holes

RTM-C

1.Place the RTM-C coupler onto the threaded end of the suspension pole. Thread the coupler onto the threaded pipe tighten at least seven (7) complete turns.

2.After the RTM-C has been threaded onto the 1-1/2” NPT, tighten the M6 x 10mm set screw using a M3 Allen wrench (supplied).

3.Use the cable management holes, along with the cable ties, to secure and hide any loose cables and wires.

Cable Management Holes

M3 Allen

Wrench

M6 x 10mm Set

Screw

Installation Instructions

Page 5