Attaching the RTM-C to the RTM

After tightening the M8 x 20mm button hex head screws, place the RTM-C to the side and determine where the suspension pole will be installed.

NOTE: Please refer to the installation instructions that are included in the packaging of the mount that will be used for the next steps.

Installation Instructions

RTM-C

NOTE: The installation instructions that are contained in this manual refer only to the RTM-C. The installation instructions for optional configurations (page 7) that are used with the RTM-C will be included with those products.

NOTE: Prior to installing the RTM-C, the RTM-C must be attached to the RTM-L or the RTM-S.

5/32” Allen

Wrench

Mounting

Block

Set Screw

Flat Edge

M8 x 20mm

Button Hex

Head Screws

1.Remove the set screws from the mounting block on your Rotary Series Mount (two are located on each side of the mounting block) using the 5/32” Allen wrench (supplied with the RTM-S and the RTM-L).

2.Place the RTM-C (flat edge facing the rear) onto the RTM and line up the mounting holes.

3.Insert four (4) M8 x 20mm button hex head screws into the mounting and tighten using the M5 Allen wrench (supplied).

RTM-C

M5 Allen Wrench

Page 4