A. FRONT PANEL SECTION FEATURES
1. BALANCE INPUT (MIC)
Electronic Balanced inputs acceptable a standard XLR male connector. It is designed to accept a balanced low impedance input signal, Phantom power (15 volts) for condenser microphones is always
on and available. It has an input impedance of 1K ohm. The connector is wired as: Pin= shield ; Pin3= negative(cold).
2. BALANCE INPUT(LINE)
Electronic Balanced inputs acceptable a standard 1/4＂ jacks connector. It is designed to accept a balanced high impedance input signal (This use for connection Deck , Turntable, Keyboard etc… ).
3. VOLUME
This is function to adjust the volume of signal connection into each channel and adjust the volume of output, together with master fader.
4. TREBLE
This control gives you up to 15 db of boost or cut at 10 kHz and above, and it is also flat at the detent. Use it to add sizzle to cymbals, and an overall sense of transparency or edge to
5. LOW FREQUENCY
This control gives you up to 15 dB boost or cut at 100Hz and below. This circuit is flat (no boost or cut) at the center detent position. This frequency represents the punch in bass drums, bass guitar, fat synch patches, and some really serious male singers.
6. REVERB DEPTH/EFFECT BALANCE
This is a send control to the reverb buss, It controls the amount of reverberation added to the Input signals.
_________________________________________________________- 3