15A 20A 30A | PYLE Audio PLA-4300D, PLA-4350, PLA-2650, PLA-219

features and specifications

2ch amp PLA-2150 • PLA-2250 PLA-2350 • PLA-2450

crossover mode selector when used with normal, full range systems, set this switch to “FULL.” If you wish to use the internal crossover to power a driver of specific frequency range, use the “LOWPASS” or “HIGHPASS” settings.

input level control use this control to match the outputs of your head unit to the amplifier. Starting with your head unit set at about the 2 o’clock position, increase the amp level control until distortion begins to occur, and reduce slightly from this point.

output power @ 14.4v DC, 1KHz	PLA-2150	PLA-2250		PLA-2350	PLA-2450
RMS Power @ 4 Ohms	40 Watts x 2	75 Watts x 2		75 Watts x 2	100 Watts x 2
RMS Power @ 2 Ohms	60 Watts x 2	125 Watts x 2		125 Watts x 2	175 Watts x 2
Maximum Power Output	300 Watts x 2	500 Watts x 2		600 Watts x 2	700 Watts x 2
frequency response			15 Hz-30 KHz

input impedance

low pass frequency control when the crossover selector switch is in “low pass” mode, this control sets the upper frequency limit for audio program sent to the speakers.

low level inputs

10K Ohms

high pass frequency control when the crossover selector switch is in “high pass” mode, this control sets the lower frequency limit for audio program sent to the speakers.

Remote Bass Boost Plug in the Remote Bass Boost Control wire in here.(PLA-2150 without)

high level inputs

input sensitivity

low level inputs high level inputs

100 Ohms

250mV

2.5V

bass boost level control this control permits adjustment of the bass level up to an increase of approximately 18 dB.

low level inputs this amp features gold-plated RCA input jacks for high impedance input. Use these with car stereo output which uses RCA-type connector cables.

high level inputs if your car stereo lacks RCA-type output jacks, you may connect speaker output leads to these input connectors.

power supply voltage

matching speaker impedance

stereo mode bridged mode

14.4V DC Neg. Ground (10.5-16V)

2-4 Ohms

4-8 Ohms

power LED this indicator is illuminated when power is applied.

protection LED this indicator is illuminated when built-in protection circuitry is activated.

power fuse the fuse protects the amplifier and your car’s electrical system from short circuit conditions.

power terminals use these connectors to deliver power, ground and remote turn-on control to the amplifier.

speaker connections these terminals are 14K gold plated to guarantee high conductivity and minimum signal loss.

maximum current draw	15A	15A	20A	30A
dimensions (W x H x L)
mm	281 x 59 x 209	281 x 59 x 280	281 x 59 x 305	281 x 59 x 343
inches	11.06 x 2.32 x 8.25	11.06 x 2.32 x 11	11.06 x 2.32 x 12	11.06 x 2.32 x 13.5