PYLE Audio PLA-2350, PLA-4300D, PLA-4350, PLA-2650, PLA-219, PLA-2750, PLA-2250 manual 20 a 30 a 20 a x

features and specifications

4 ch amp PLA-4150 • PLA-4250 • PLA-4350

dual crossover mode selectors

dual input level controls

dual low pass frequency controls

dual high pass frequency controls

CH 3/4 Remote Bass Boost dual bass boost level controls

low level inputs

high level inputs

power LED

when used with normal, full range systems, set these switches to “FULL.” If you wish to use the internal crossovers to power a driver of specific frequency range, use the “LOWPASS” or “HIGHPASS” settings.

use these controls to match the outputs of your head unit to the amplifier. Starting with your head unit set at about the 2 o’clock position, increase the amp level controls until distortion begins to occur, and reduce slightly from this point.

when one or both of the crossover selector switches is in “low pass” mode, one can set the upper frequency limit for audio program sent to the speakers.

when the one or both of crossover selector switch is in “high pass” mode, one can set the lower frequency limit for audio program sent to the speakers.

Plug in the Remote Bass Boost Control wire in here.(PLA-4150 without)

this control permits adjustment of the bass level up to an increase of approximately 18 dB in either or both pairs of channels.

this amp features gold-plated RCA input jacks for high impedance input. Use these with car stereo output which uses RCA-type connector cables.

if your car stereo lacks RCA-type output jacks, you may connect speaker output leads to these input connectors.

this indicator is illuminated when power is applied.

output power @ 14.4v DC, 1KHz PLA-4150 PLA-4250 PLA-4350

RMS Power @ 4 Ohms	35 Watts x 4		50 Watts x 4	75 Watts x 4
RMS Power @ 2 Ohms	55 Watts x 4		75 Watts x 4	115 Watts x 4
Maximum Power Output	250 Watts x 4		350 Watts x 4	500 Watts x 4
frequency response			15 Hz-30 KHz
input impedance
low level inputs			10K Ohms
high level inputs			100 Ohms
				16
input sensitivity
low level inputs			250mV
high level inputs			2.5V
power supply voltage		14.4V DC Neg. Ground (10.5-16V)
matching speaker impedance
stereo mode			2-4 Ohms
bridged mode			4-8 Ohms
maximum current draw	20 A		30 A	20 A x 2
dimensions (W x H x L)

protection LED power fuse

power terminals

speaker connections

this indicator is illuminated when built-in protection circuitry is activated.

the fuse protects the amplifier and your car’s electrical system from short circuit conditions.

use these connectors to deliver power, ground and remote turn-on control to the amplifier.

these terminals are 14K gold plated to guarantee high conductivity and minimum signal loss.

mm	281 x 59 x 305	281 x 59 x 381	281 x 59 x 432
inches	11.06 x 2.32 x 12	11.06 x 2.32 x 15	11.06 x 2.32 x 17