KEY TO THE VACUUM CLEANER'S PARTS
1.Handle
2.Air valve
3.Telescopic tube
4.Parking system
5.Locking mechanism
6.Hose connector
7.Carrying handle
8.Vertical parking holder
9.Storage compartment for special nozzles
10.Button for opening storage compartment
11.Handle for opening dust bag container
12.Exhaust grille
13.Handle for removal of exhaust grille
14.Start/stop button
15.Suction force regulation
16.Button for automatic cord rewind
17.Bag change indicator
18.Vertical parking holder
19.Automatic cord rewind
20.Floor nozzle
21.Brush change button
22.Extra nozzle for hard floors
23.Furniture nozzle
24.Joint nozzle
25.Brush nozzle
| 17. |
| |
18. | 16. |
| |
9. | 25. | ||
| |||
15. |
| 10. |
14.
7.
24.23.
11.
20.21.
22.
1.
2.
4.
3.
5.6.
13.
19.
12.8.
PREPARING THE VACUUM
CLEANER
•Fit the hose on the vacuum cleaner by inserting the rotating hose connection
(6) into the vacuum cleaner until you hear a click. To remove the hose, press the button at the side of the hose connection and pull it out.
•Fit the telescopic tube (3) into the other end of the hose, and fit a floor nozzle (20 or 21) to the end of the tube.
•You can adjust the length of the telescopic tube by pushing the locking mechanism (5) down and pulling in the bottom section of the tube to a suitable length. When parking, shorten the tube as far as possible.
•The vacuum cleaner’s three special nozzles (23, 24, 25) are kept in the storage compartment (9), which is opened by pressing the button (10). Remove the floor nozzle and fit the special nozzle required to the end of the telescopic tube.
15