INSTALLATION OF RECEIVER
CONNECTING THE RECEIVER TO A TV
STEP 2:
You have two options to connect the Receiver: A) Using RCA Cables (see below), or B) Coaxial Cables, please refer to page 7 of this manual.
A) | Back of Receiver | Television |
| ||
|
|
Electrical Outlet
NOTE | Ensure the Power Switch on the Receiver is turned OFF before | |
proceeding with the following steps. | ||
|
1.Place the wireless receiver near your television (or monitor).
2.Connect one end of the RCA cables to the Audio/Video output jacks at the back of the receiver. Plug the other end of RCA cables into the Audio/Video In jacks on your television. Be sure the yellow, red and white plugs match the yellow, red and white jacks on both the receiver and TV.
3.Connect one end of the supplied 9V AC adapter into the DC IN
jack at the back of the receiver; the other end into an electrical outlet. Turn the receiver ON. The system is defaulted to channel 1.
4.Turn your TV to AX (Aux. Mode or TV/Video) to view the camera picture on your TV.
5.Adjust the antenna on the receiver if necessary for optimum viewing.
|
|
|
NOTE | For optimum viewing reception you may need to change the | |
channels of both your camera and receiver to the same | ||
|
| channels between CH 1 – CH 4 |
6