X10 Wireless Technology DS7000 manual Contents

READ THIS FIRST

This equipment generates and uses radio frequency energy, and if not installed and used properly, that is, in strict accordance with the manufacturers instructions, may cause interference to radio and television reception. It has been type tested and found to comply with the limits for remote control security devices in accordance with the specifications in Sub-Parts B and C of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by unplugging the equipment, try to correct the interference by one or more of the following measures.

•Reorient the antenna of the radio/TV experiencing the interference.

•Relocate the console with respect to the radio/TV.

•Move the console away from the radio/TV.

•Plug the console into an outlet on a different electrical circuit from the radio/TV experiencing the interference.

If necessary, consult X10 Technical Support for additional suggestions.

The Security Console’s telephone dialer is designed to conform to federal regulations, and it can be connected to most telephone lines. However, each telephone or telephone device that is connected to the telephone line draws power from the telephone line. This is referred to as the device’s ringer equivalence number, or REN.

If more than one telephone or other device is connected to the same line, add up all the RENs. If the total is more than five, the telephones might not ring. In rural areas, a total REN of three might impair ringer operation. If ringer operation is impaired, remove one of the devices from the line.

Note: The console must not be connected to:

•Coin-operated systems

•Party-line systems

•Most electronic key telephone systems

The console’s telephone dialer complies with Part 68 of FCC Rules.You must, upon request, provide the FCC registration number and the REN to the local telephone company. Both numbers are shown on the bottom of the console.

The telephone portion of the Security Console has been tested and found to comply with all applicable UL and FCC standards.

In the unlikely event that the console causes problems on the telephone line, the telephone company can disconnect service. The telephone company attempts to notify you in advance. If advance notice is not practical, the telephone company notifies you as soon as possible and advises you of your right to file a complaint with the FCC.

Also, the telephone company can make changes to its lines, equipment, operations, or procedures that could affect the operation of this console. The telephone company notifies the owner of these changes in advance, so the necessary steps can be taken to prevent interruption of telephone service.

Note: The security functions of this system have not been tested by Underwriters Laboratories.

Contents
Introduction	4
Installation	5
Locating Security System components	5
Security Console	6
Security Remote	7
Keychain Remote	8
Door/Window Sensor	9
Motion Detector	10
Power Horn	12
Lamp Module	13
Other X10 Products	14
Setting Up the Dialer	15
Programming Phone Numbers	15
Recording a Voice Message	15
Using the Security System	16
Console Zone Indicators	16
Arming and Disarming the System	16
Battery Information	18
General	18
Security Console	18
Handheld and Keychain Remotes	18
Door/Window Sensor and Motion Detector	19
Clearing remotes & sensors from the console	19
Troubleshooting	20

2 3