X10 Wireless Technology DS7000 manual Setting up the Dialer, Other X10 products sold separately

Installation

Other X10 products (sold separately)

Setting up the Dialer

Programming Phone Numbers

O	•	A	•	C
•				•
M				E
•				•
K	•	I	•	G
15	•	1	•	3
•				•
13				5
•				•
11	•	9	•	7

PM

Mini Timer

1			A
13	5	M	E
9			I

Remote Switch

O	• A •			C
•				•
M				E
•				•
K	•	I	•	G

ON OFF

1-8 9-16

Note: you should program the console to call a friend, relative or neighbor who can then listen-in to your home to determine if there is a real problem. The person can then call the Police if necessary, or call you back to see if everything is fine. You should NOT program the console to dial the Police directly.

1.Set the console to INSTALL.

2.Press the PROG button.

3.Enter the first phone number that you want the console to call in the event of a problem.

4.Press the MEM button.

5.Press 1 to store the phone number in memory location 1. Press PROG, enter second phone number, press MEM, 2. Press PROG, enter third phone number, press MEM, 3. Press PROG, enter fourth phone number, press MEM, 4.

Repeat the above process to change a phone number.

Modules

A wide range of switch and control modules are available from X10, all of which can be controlled from the same remote controls which are used to operate the security system. Modules available include replacement wall switches, X10 controlled AC outlets, screw-in lamp modules, plug-in appliance modules and many others.

Remotes

As well as being able to add up to 16 security remotes to the system, you can also add any number of Home Automation wireless remotes such as the handheld PalmPad™ remote which controls up to 16 modules around the home.

Controls

A range of plug-in controllers are available including the Mini Timer which controls up to four modules with two on/off times each day, the Touch-Tone Controller which lets you use any touch tone telephone to call home and control X10 modules, and products which allow any Windows™ based PC to control X10 Modules.

Special products

For special installation requirements a range of accessory products are available including powerline filters for multiple installations in close proximity, RF and powerline repeaters for larger installations and interface modules to tie-in X10 control with third party security products.

Note: if you only want to program one phone number, you should store this number in all four memory locations.

Storing a Voice Message

1.Set the console to INSTALL.

2.Press the RECORD button. The BUSY light turns on.

3.Speak clearly into the microphone on the front of the console. You can record up to 15 seconds of speech. For example: “There is a burglary in progress at (address). Press 0 to listen-in.”

After 15 seconds the BUSY light turns off.

4.Plug the earphone into the jack on the side of the console.

5.Set the console to RUN. The console plays back your message through the earphone so you can hear what it sounds like (it sounds better when played back over the telephone line).

6.If you want to hear the message again, set console to INSTALL then back to RUN. Repeat above steps to change the message.

14 15