Operation

Notes:

•If your receiver/amplifier has more than one set of speaker terminal (A and B), connect only one or the other to the control center.

•For the best results, we recommend 14-gauge, two conductor speaker wire (not supplied) for most connections. If you plan to located the speakers further than 80 feet from the control center, use a heavier gauge of wire.

Caution:To avoid damaging your receiver/amplifier, set its volume to the lowest setting before changing the control center’s settings.

To turn on a pair of speakers connected to the control center, simply press in the desired button. For example, to turn on the set of speakers connected to SPK A, press A.

To turn off a pair of speakers, press the button again so it is in the “out” position.

Note:if no speakers are connected to a set of terminals, do not press in the corresponding control button.