HoMedics IB-WFLRVRB Assembly and Instructions for Use, Do not plug into outlet at this time Fig

CAUTION CONTINUED

•The electrical cord of this product cannot be replaced. If it sustains damage, you must stop using this product immediately and return it to the HoMedics Service Center for repair. (See the warranty section for HoMedics address.)

•Disconnect the appliance from outlet before putting hands into water.

Assembly and Instructions for Use

1.Unpack the product. Wipe off dust with a damp cloth.

2.Familiarize yourself with the pump. The pump speed is controlled by the dial located at the front of the pump. The speed is indicated by a “min” and “max” (Fig 1). At its highest speed level, the dial will cease to move any further. To decrease the pump speed, move the dial counter-clockwise toward the “min”sign. Similarly, at its lowest speed, the dial will cease to move any further.

3.Lead the cord through the cord slot on the bottom of the base. This will ensure that the unit is balanced when placed on a flat surface. Attach the A/C adaptor jack to the base power cord.

DO NOT plug into outlet at this time (Fig. 2).

Figure 2
		Top Tier
Stones
	LED Light	Water Supply
Figure 1	Connector
	Outlet	Connector
	Middle Tier		Cut-Out
	LED Light Cord		Stones
	Cut-Out	PVC
		Tube
			Pump
			Platform
Base Power
Cord			Watermark
		Base
Switch	Supporting	Edge	Base
	Poles
	Adaptor

Figure 3

Cut-Out	PUMP
	Drawing on Base
Base Edge

Figure 4

LED Light Socket	Top Tier
	Water Supply Connector
LED Light	Larger Hole
	Middle
Connector	Tier

Figure 5

Stones

Water

Watermark

Figure 6 Figure 7

Drip Loop

4.Place the platform on the supporting poles of the base (Fig. 2).

5.Insert the PVC tube located under middle tier into the pump (Fig. 2).

6.Insert the LED light cord through the small hole located under the middle tier (Fig. 2).

7.Align the cut-out at the bottom edge of middle tier with the edge of base so it sits flat on the base (Fig. 3).

NOTE: Pump position should be corresponding to the drawing on base.

8.Insert the LED light connector into the LED light socket on the bottom of top tier, and then insert the water supply connector on the bottom of top tier into the larger hole of middle tier (Fig. 4).

9.Add clean water into middle tier (Approx. 10oz), and then into base (Approx. 56.5oz). The water level should be even with thewatermark. Next, arrange the stones provided on top tier, middle tier and the platform as desired (Fig. 5).

10.Plug the cord into 120V household outlet. The fountain is controlled by the switch located on the power cord. If pump doesn’t operate, rotate in-line switch once to turn “on” and once more to turn “off”.

NOTE: Ensure that the electrical cord loops below the electrical outlet to form a ‘Drip Loop’ (Fig. 6). This will prevent water from running down the cord into the electrical outlet.

11.As this product has two flowing directions, unplug the power source before changing fountain position. To do so, turn top tier counter clockwise 90 degrees. When water has stopped flowing from it, switch the fountain back on (Fig. 7).

4

5