Land Pride
Assembly Instructions
!CAUTION
TO AVOID PERSONAL OR OTHER INJURY:
1.READ BLADE OWNER’S MANUAL, MACHINE’’’S OPERATOR’S MANUAL, AND SAFETY DECALS BEFORE OPERATING.
2.WEAR HEAD PROTECTION, SAFETY GLASSES, AND SHOES AS RECOMMENDED IN ATV OPERATOR’S MANUAL.
3.ALLOW NO RIDERS ON BLADE OR MACHINE WHILE MOVING OR STATIONARY.
4.KEEP BYSTANDERS AWAY FROM BLADE AND ATV WHILE MOVING OR STATIONARY.
5.BEFORE ADJUSTING BLADE ANGLE, STOP THE MACHINE’S ENGINE, SET AND LOCK BRAKES, RAISE BLADE. DO NOT ATTEMPT TO RAISE BLADE BY HAND; USE THE LIFT ONLY.
6.BEFORE ADJUSTING BLADE HEIGHT: LOWER BLADE TO THE DOWN POSITION.
7.WHEN BLADE IS NOT IN USE, STOP THE MACHINE’S ENGINE, SET AND LOCK BRAKES, AND LOWER BLADE TO DOWN
!! ! OPERATION! ! !
**Your blade and hardware were designed with your safety in mind. In order to protect you and your machine, certain parts of the blade and / or hardware are designed to fail when the equipment is over stressed. For this reason Push Tubes, Blade Hinges, Push Plate Attaching Pins and Clevis Pins are not covered by Warranty.
*Blade angle is adjustable. Raise blade. To move the blade left, right or straight, pull the Blade Position Lever ahead and turn the blade to the desired position. The Lever will spring back when the blade is at the correct angle.
*The blade skids are adjustable so the blade can be lowered but still held a certain distance off the ground.
*The blade is designed to trip when it strikes an object or digs in too far. When pressure is released the blade springs back into position. Blade spring tension may be set stiffer by tightening the Locknuts on the bottom of the Eyebolts. For less spring tension, loosen the Locknuts.
*Do not exceed 5 MPH with blade installed.
*Operate with extreme caution on slopes, steep grades and rough terrain.
*Keep away from blade and moving parts during operation.
installed
OPERATION TIPS
When plowing snow or dirt into a pile, back away from the pile before attempting to raise the blade
!For best results set the suspension to the stiffest setting if possible
!The Blade is shipped with the Blade Skids mounted upside down for boxing. Be sure to mount the Skids properly before using your blade.
MAINTENANCE
!Periodically check for wear and tightness of all bolts, nuts and fasteners. Replace or tighten as necessary.
NOTICE
!The use of Blade Lift Kits Not Manufactured by Land Pride with Work Power Blades will void all warranties.
!The Land Pride Blade Lift Kits are specifically designed to help prevent damage to the Blades, Lift Kits and the machine.
!PREPARATION:
Using the Parts List and Parts Drawing included, verify that you have received all the components of the 701- 069A Electric Lift Kit.
NOTE: The MACHINE needs to be on a level surface.
All directions referring to the right and the left are when the operator is sitting on the machine.
Numbers in parenthesis refer to item numbers on the parts list and parts drawing at the end of the instructions
Assembly Instructions
A detailed listing of parts for this accessory kit is provided on page 6. Use the list as a checklist to inventory parts received. Please contact your local Land Pride dealer for any missing hardware.
Using the two 3/8" x 1" bolts (#12) and Nylock Nuts supplied, securely fasten the Electric Lift Assembly to the U608 Blade Position Lever Bracket as shown below.
!WARNING
!Due to reduced ground clearance, remove plow Mount
Brackets before trail riding.
! Do not exceed 5 MPH with the blade or its brackets
2 | Manual No. | ■ 06/21/07 |
