Land Pride
Assembly Instructions
is a fuse in the fuse holder. Turn the key switch to the on position and test run the lift motor by pressing the up button on the handlebar switch.
Verify that pressing the up button on the handle bar switch causes clockwise rotation of the spool when viewed from the open end. (See illustration below). If the spool rotates counterclockwise, see the note on the electric lift
wiring harness diagram on the previous page. The spool should now rotate in the clockwise direction when pressing the top button.
Run the spool in the direction necessary to end up with one wrap of cable on the spool and the cable to the front side of the spool.
With the blade resting on the ground, route the end of the cable up through the quick link (#8) in the lift strap (#6), and secure it with the Cable Clamp (#7).
NOTE: If the Blade is raised too high, the Push Tube will contact the ATV frame and put an excessive load on the Gear Motor and other parts. Failure of the fuse may result. Stop the blade at a point before this contact occurs.
ALSO: Be aware that if the switch is held in the "DOWN" position after the Blade has contacted the ground, the cable will start to wind up backwards on the Spool.
A drop of oil on each end of the spool will keep the spool lubricated. Do this periodically
06/21/07 ■ | Manual No. | 5 |
