Land Pride
Assembly Instructions
Switch Installations
Choose a place for the switch assembly that is free from obstructions and does not interfere with the normal functions of the machine.
Method One:
Place the 13/16 Vinyl Coated Cable Clamp (#16) around machine’s front rack and secure using one
head Bolt (#19), #10 Star Washer (#17), 5mm Flat Washer (#18),
Method Two:
This method you will not use the Switch Housing (#14). Locate a convenient place on the dash to mount the
switch. Cut a rectangular hole 7/8" x 1 ". Press the switch into the rectangular hole. See picture below.
Route the Red and Black wires to the battery.
These wires must be well clear of any moving parts on the machine
Do not allow the wires to come in contact with any hot parts of the machine, such as the exhaust or cylinder head.
Secure the ring terminal on the black wire to the battery negative post.
Install the ring terminal on the
Route the red and brown leads of the Wiring Harness (#27) to the front of the machine and connect to the lift
motor plug.
These wires must be well clear of any moving parts of the machine
Do not allow the wires to come in contact with any hot parts on the m achine such as the exhaust or cylinder head
Allow plenty of slack for vertical movement of the plow between the tie point on the machine and the electric lift motor.
Plug the Relay (#13) into the relay socket on the Wiring Harness (#12).
With a
Use the blue scotch lock (#22) tap connector to connect the yellow wire from the electronic module to this wire.
Note: Failure to connect the yellow wire to a wire that is energized only when the ignition switch is in the "on" position, will discharge the battery.
Check your electrical connections and make sure there
4 | Manual No. | ■ 06/21/07 |
