ASSEMBLY
TO ASSEMBLE AND A'I'rACH GRASS
CATCHER (See Figs. 3A thru 4)
•To assemble tubular frame to grass bag, work sewn hem of bag out through the front opening of bag to expose the hem.
•Thread tubular frame into hem and gather material at top of frame as shown.
•Push frame inside bag through the opening until only the ends of frame are exposed out of the front.
NOTE:" Do not close the flip lid at this time.
•Assemble lower frame to tubular frame as shown. Be sure frames are fully seated together as shown in inset.
•Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold them in warm water for a few minutes. If bag gets wet, let it dry before
using.
•Close the flip lid. Flip lid must be closed while operating lawn mower.
Lift the rear door on the mower housing and place the
dgrasscatcher frame onto the formed tabs on the rear oor hinge bracket.
The grass catcher is secured to the lawn mower housing when the rear door is lowered onto the grass catcher frame.
FLIP LID
SEWN
HEM (Pull out through front of opening)
FIG. 3A
SEWN
HEM
TUBULAR FRAME
(Thread into sewn hem)
FIG. 3B
_TUBULAR
FIG. 3C
LOWER
TUBULAR
FRAME
(Frames must be fully seated)
FIG. 3D
CATCHERFRAME
\
FIG. 3E
HINGE
GRABS CATCHER FRAME
FORMED
TABS
FIG. 4
7
