RESTRICTED USE ONLY | Fargo Electronics, Inc. |
Replacing the Lid Sensor Assembly (810174)
Refer to Drawing D810024
Estimated Repair Time: 15 minutes.
Steps | Procedures |
|
|
1 |
|
| Caution: Turn off the Printer and unplug the power cord from the |
| Printer. |
|
|
2 | Open the Upper Imaging Assembly. |
|
|
3 | Remove the screw (130972) from the Lid Sensor Assembly. |
|
|
4 | Loosen the top two corner screws (130987) found just behind the top edge of |
| the Rear Cover. |
|
|
5 | Close the Upper Imaging Assembly. |
|
|
6 | Remove the screw (130987) by the Card Exit Ramp. |
|
|
7 | Remove the Rear Cover. |
|
|
8 | Remove the two screws (130971) that secure the Print Circuit Board to the two |
| Standoff screws (140047). |
|
|
8 | Remove the screws that hold the Main Board Brackets in place. |
|
|
9 | Use the thumb and index fingers of both hands to carefully pry the Print Circuit |
| Board from the Power Circuit Board. |
|
|
10 | Disconnect the cable connector from J4 on the Print Circuit Board. |
|
|
11 | Take the Lid Sensor Assembly from the Printer. |
|
|
Persona C16 Card Printer Service Manual (Rev. 5.0) | 181 |