FARGO electronic C16 Printer Components Top Cover to Parallel Interface Card, Description

RESTRICTED USE ONLYFargo Electronics, Inc.

Printer Components: Top Cover to Parallel Interface Card

Components	Description
Top Cover	This cover opens to allow access to the Printhead, print ribbon and card
	path. (Note: This cover must be closed in order for the Printer to begin
	printing.)
Release tab	This tab unlatches the Top Cover.
Printhead	This Printer component actually does the printing. (Note: This
	component is fragile and must not be bumped or touched with anything
	other than a cleaning pen.)
On/Cancel	The On/Cancel button turns the Printer ON and OFF. (Note: It also
button	serves to cancel the current print job and reset the Printer for the next
	print job.)
	If a card is left within the Printer after a print job is canceled, it will
	automatically be ejected when the Printer is turned back ON.
Pause/Resume	The Pause/Resume button is used to pause the Printer during normal
button	operation and also to resume operation after an error condition is
	cleared.
	Note #1: In general, as the icon above this button indicates, errors are
	related to either the ribbon or the cards. If an error occurs, the Media LED
	will flash.
	Note #2: The Printer must have both the Power LED and the Media LED
	illuminated in order to print. See Reviewing the LCD Error/Status
	Messages in section 2, page 22 for more information.
Card Cleaning	This roller automatically cleans cards for higher print quality. (Note:
Roller	Clean the Card Cleaning Roller during every ribbon change (every 250
	cards) or as needed.)
Card Input	Load blank cards into this Hopper.
Hopper
Power Port	This port connects to the (included) power cord.
Parallel	This port connects to a Windows PC with a parallel cable.
Interface Port

Persona￿ C16 Card Printer Service Manual (Rev. 5.0) 13