RESTRICTED USE ONLY

Fargo Electronics, Inc.

Replacing the Ribbon Drive Motor Assembly (830147)

Refer to Drawing 830117-XX

Estimated Repair Time: 15 minutes.

Steps

Procedures

 

 

1

 

 

Caution: Turn off the Printer and unplug the power cord from the

 

Printer.

 

 

2

Open the Upper Imaging Assembly.

 

 

3

Loosen the top two corner screws (130987) found just behind the top edge of

 

the Rear Cover.

 

 

4

Close the Upper Imaging Assembly.

 

 

5

Remove the screw (130987) by the Card Exit Ramp.

 

 

6

Remove the Rear Cover.

 

 

7

Remove the two screws (130971) that secure the Print Circuit Board to the two

 

Standoff screws (140047).

 

 

8

Remove the screws that hold the Main Board Brackets in place.

 

 

9

Use the thumb and index fingers of both hands to carefully pry the Print Circuit

 

Board from the Power Circuit Board.

 

 

10

Remove all of the cables from the Circuit Boards.

 

 

11

Remove the three screws (130938) from the Ribbon Drive Assembly.

 

 

12

Take the Ribbon Drive Assembly from the Printer.

 

 

13

Take care to keep the Shaft from binding with the casing of the Ribbon Drive

 

Assembly before tightening the three screws.

 

 

Personaï¿¿ C16 Card Printer Service Manual (Rev. 5.0)

172

Page 181
Image 181
FARGO electronic C16 service manual Replacing the Ribbon Drive Motor Assembly