FARGO electronic C16 service manual Replacing the Printhead Assembly, Refer to Drawing

RESTRICTED USE ONLY Fargo Electronics, Inc.

Replacing the Printhead Assembly (081524)

Refer to Drawing 830119-XX

Estimated Repair Time: 10 minutes.

Warning: If oil or debris makes contact with the Printhead elements, wipe the glass-coated area of the printhead immediately with a Printhead Cleaning pen. See Cleaning the Printhead in section 4, page 150.

Steps	Procedure
1
	Caution: Turn off the Printer and unplug the power cord from the
	Printer.
2	Open the Upper Imaging Assembly.
3	Unscrew the two Thumb screws (130887).
4	Remove the Head Cover Plate (820253).
5	Raise the tip of Head Spring (810214) about ¼ -inch above the Printhead
	Assembly (820199).
6	Remove the spacer from the top of the Printhead Assembly.
7	Grasp the two plastic forks on each side of the Printhead Assembly, pivot them
	upward and release the Head Spring.
8	Disconnect the two cables from the printhead.
9	Guide the Printhead Assembly between the side plates and out of the Printer.

Persona￿ C16 Card Printer Service Manual (Rev. 5.0) 166