
RESTRICTED USE ONLY | Fargo Electronics, Inc. |
Removing and replacing the Idler Springs on the C11 Card Printer with the Magnetic Encoder (continued)
Step | Procedure |
|
|
6 | Follow these steps to install the new parts for the Idler Spring that is furthest |
| away from the Magnetic Encoder: |
| a. Install one (1) spacer (D810050) onto the Posts. |
| b. Install one (1) Roller (D810040). |
| c. Install one (1) Idler Spring (D830068) on top of the Roller. |
| d. Install two (2) screws (F000170) with two (2) washers (140040) onto each |
| Post. |
| Caution No. 1: Do not |
| Caution No. 2: When installing the springs, ensure that the spring is |
| centered about the centerplate tabs, so that the tabs do not interfere with the |
| spring. |
|
|
7 | Replace the bottom access cover and fasten the two (2) screws. |
|
|
8 | Turn the Printer upright. |
|
|
| Continued on the next page |
Persona C16 Card Printer Service Manual (Rev. 5.0) | 199 |