RESTRICTED USE ONLY | Fargo Electronics, Inc. |
Replacing the Front Panel Board Assembly (A000265)
Refer to Drawings 830117, 830118 and 830119.
Estimated Repair Time: 20 minutes.
Steps | Procedure |
|
|
1 |
|
| Caution: Turn off the Printer and unplug the power cord from the |
| Printer. |
|
|
2 | Open the Upper Imaging Assembly. |
|
|
3 | Remove the top two corner screws (130987) found just behind the top edge of |
| the Front Cover. |
|
|
4 | Close the Upper Imaging Assembly. |
|
|
5 | Remove the screw (130987) by the Card Exit Ramp. |
|
|
6 | Remove the Front Cover |
|
|
7 | Remove the five screws that hold the Front Panel Board in place |
|
|
8 | Open the Upper Imaging Assembly. |
|
|
9 | Loosen the top two corner screws (130987) found just behind the top edge of |
| the Rear Cover. |
|
|
10 | Close the Upper Imaging Assembly. |
|
|
11 | Remove the screw (130987) by the Card Exit Ramp. |
|
|
12 | Remove the Rear Cover. |
|
|
13 | Disconnect the cable from J2 and J24 on the Print Circuit Board. |
|
|
14 | Take the Front Panel Board Assembly from the Printer. |
|
|
Persona C16 Card Printer Service Manual (Rev. 5.0) | 169 |