RESTRICTED USE ONLY | Fargo Electronics, Inc. |
Resolving the Ribbon Error/Out Error Message
Symptom: A Ribbon Error/Out message is displayed on the LCD
Step | Procedure | |
|
| |
1 | Calibrate the Ribbon Sensor. | |
| a. | Reset the Printer to clear any Error Messages by removing Power and |
|
| reapplying. |
| b. | From the Computer, open the Printer control panel. |
|
| • If using Windows 95/98/ME, right click on the C11_C16 Card Printer Icon |
|
| and select Properties. |
|
| • If using Windows NT 4.0, right click on the C11_C16 Card Printer and |
|
| select Document Defaults. |
|
| • If using Windows 2000/XP, right click on the C11_C16 Card Printer and |
|
| select Printing Preferences. |
| c. | Click the Calibrate tab. |
| d. | Click on the Sensors button. (See the next page.) |
| e. | Remove the Ribbon and close the top cover. |
| f. | Click on the Send button for a Ribbon Sensor Calibration. |
| g. | Verify that the Printer should then beep twice. |
| h. | If the Printer does not beep twice, see Communications Errors in Section 2, |
|
| page 22. |
|
|
|
Persona C16 Card Printer Service Manual (Rev. 5.0) | 40 |