FARGO electronic C16 service manual Parts Replacement, Safety Messages review carefully

RESTRICTED USE ONLY Fargo Electronics, Inc.

Section 5: Parts Replacement

This Section describes the replacement of key components of this Card Printer.

Step	Procedure
1	Be sure to reverse the disassembly steps to reassemble the Card Printer.
Safety Messages (review carefully)
Symbol		Critical Instructions for Safety purposes
Danger:		Failure to follow these installation guidelines can result in death or
		serious injury.
		Information that raises potential safety issues is indicated by a warning
		symbol (as shown to the below).

•To prevent personal injury, refer to the following safety messages before performing an operation preceded by this symbol.

•To prevent personal injury, always remove the power cord prior to performing repair procedures, unless otherwise specified.

•To prevent personal injury, make sure only qualified personnel perform these procedures.

Caution:	This device is electrostatically sensitive. It may be damaged if
	exposed to static electricity discharges.
	Information that raises potential electrostatic safety issues is indicated
	by a warning symbol (as shown to the below).
	• To prevent equipment or media damage, refer to the following
	safety messages before performing an operation preceded by this
	symbol.
	• To prevent equipment or media damage, observe all established
	Electrostatic Discharge (ESD) procedures while handling cables in
	or near the Circuit Board and Printhead Assemblies.
	• To prevent equipment or media damage, always wear an
	appropriate personal grounding device (e.g., a high quality wrist
	strap grounded to avoid potential damage).
	• To prevent equipment or media damage, always remove the
	Ribbon and Cards from the Printer before making any repairs,
	unless otherwise specified.
	• To prevent equipment or media damage, take jewelry off of
	fingers and hands, as well as thoroughly clean hands to remove oil
	and debris before working on the Printer.

Persona￿ C16 Card Printer Service Manual (Rev. 5.0) 155