RESTRICTED USE ONLY | Fargo Electronics, Inc. |
Replacing the Ribbon ID Sensor Board Assembly (820543)
Refer to Drawing D810024
Estimated Repair Time: 30 minutes.
Steps | Procedures |
|
|
1 |
|
| Caution: Turn off the Printer and unplug the power cord from the |
| Printer. |
|
|
2 | Open the Upper Imaging Assembly. |
|
|
3 | Remove the top two corner screws (130987) found just behind the top edge of |
| the Front Cover. |
|
|
4 | Close the Upper Imaging Assembly. |
|
|
5 | Remove the screw (130987) by the Card Exit Ramp. |
|
|
6 | Remove the Front Cover |
|
|
7 | Remove the Retaining Ring (140009). |
| Use a replacement Retaining Ring when installing the new Ribbon ID Sensor |
| Board Assembly. |
|
|
8 | Extract the Right Ribbon Hub (763345) and the Clutch Spacer (760386) off of |
| the Hub Linkage Assembly (810115). |
|
|
9 | Move the Ribbon ID Sensor Board Assembly off of the Hub Linkage Assembly. |
| (Note: Take care not to misplace the Spring; it can remain on the Hub Linkage |
| Assembly.) |
|
|
10 | Loosen the top two corner screws (130987) found just behind the top edge of |
| the Rear Cover. |
|
|
11 | Close the Upper Imaging Assembly. |
|
|
12 | Remove the screw (130987) by the Card Exit Ramp. |
|
|
Continued on the next page
Persona C16 Card Printer Service Manual (Rev. 5.0) | 182 |