RESTRICTED USE ONLYFargo Electronics, Inc.
Replacing the Ribbon ID Sensor Board Assembly (820543) (continued)
Steps | Procedures |
|
|
13 | Remove the Rear Cover. |
|
|
14 | Remove the two screws (130971) that secure the Print Circuit Board to the two |
| Standoff screws (140047). |
|
|
15 | Remove the screws that hold the Main Board Brackets in place. |
|
|
16 | Use the thumb and index fingers of both hands to carefully pry the Print Circuit |
| Board from the Power Circuit Board. |
|
|
17 | Disconnect the cable connection from J10 on the Print Circuit Board. |
|
|
18 | Take the Ribbon ID Sensor Board Assembly from the Printer. |
|
|
Persona C16 Card Printer Service Manual (Rev. 5.0) | 183 |