
RESTRICTED USE ONLY | Fargo Electronics, Inc. |
Using the Magnetic Offset option (continued)
Step Procedure
1Click on the left arrow
to enter a positive value to move the start of the magnetic data more toward the leading edge of the card or the card output to the side of the Printer.
OR
Click on the right arrow
to enter a negative value to move the start of the magnetic data toward the trailing edge of the card or the card input to the side of the Printer.
•Magnetic Data Direction: The arrows on these buttons indicate the direction the magnetic data will move on the card's Magnetic Stripe.
•Maximum Adjustment Range: The maximum adjustment range is ±100. As a
rule, 10 equals about .030"/. 8mm.) (Note: Keep this in mind when adjusting this option to avoid
Caution: If the negative value is set too high, the Printer may start Encoding before the card's Magnetic Stripe reaches the Encoding head.
Rear of Printer
+
-
Card Output | Magnetic Track Data | Card Input |
Side of Printer |
| Side of Printer |
(Leading Edge |
| (Trailing Edge |
of Card) |
| of Card) |
Direction card travels through printer
Front of Printer
Persona C16 Card Printer Service Manual (Rev. 5.0) | 83 |