
RESTRICTED USE ONLY | Fargo Electronics, Inc. |
Using the DIP Switch (Self-test)
Step Procedure
1Activate any of these diagnostic tests and Calibration modes. See Running the Self Test in Section 2, page 63. During the activation of the
•Detect the change to the DIP Switch Settings. See Using the DIP Switch Self Test in Section 2, page 64.
•Operate the Printer in that selected Test or Calibration mode.
2Return all the DIP switches back to their normal OFF position once the tests are completed.
3Leave the associated DIP switches activated to operate the Printer this way or temporarily use the settings to test a particular Printer operation. (Note: When altering a particular
4When completed, turn OFF the power to the Printer to reset the operating mode of the Printer.
•The first illustration (below) shows all eight (8) switches in the normal OFF position.
•The second illustration (below) shows Switches No. 1,2 and 3 in the ON position. (Note: The Ribbon Sensor calibration without the need of a PC).
(Note: Refer to the DIP Switch Settings table on the next page for additional diagnostic selections.)
Persona C16 Card Printer Service Manual (Rev. 5.0) | 64 |