FARGO electronic C16 Access Level-2 ID# 35“ 1.9“, Karen Atkins, Continued on the next page

RESTRICTED USE ONLYFargo Electronics, Inc.

Using the Defined Area Option (continued)

Step Procedure

2When the card grid is first activated, a small black square will appear at its default size of .2" x .2"/5mm x 5mm and at its default location in the lower left- hand corner (0,0). This square represents the first defined area.

•Determine the area of the card needed to define for a signature panel with a different size and location than the driver's standard Omit Signature Area setting. (Note: This area is indicated by the dashed outline.)

•Determine the area size by actually printing a card and looking at it in the same orientation as when it exits the Printer.

3Measure the total size of the desired area and enter those dimensions into the dimension boxes. (Note: The minimum size an area is .2" x .2"/5mm x 5mm.)

Continued on the next page

Karen Atkins

Access Level-2

ID# 1234478

.35“

1.9“

Persona￿ C16 Card Printer Service Manual (Rev. 5.0) 121