FARGO electronic C16 service manual Replacing the Card Feed Roller D830058 Center

RESTRICTED USE ONLY Fargo Electronics, Inc.

Replacing the Card Feed Roller (D830058) - Center

Refer to Drawing D810025

Estimated Repair Time: 30 minutes.

Steps	Procedure
1
	Caution: Turn off the Printer and unplug the power cord from the
	Printer.
2	Open the Upper Imaging Assembly.
3	Loosen the top two corner screws (130987) found just behind the top edge of
	the Rear Cover.
4	Close the Upper Imaging Assembly.
5	Remove the screw (130987) by the Card Exit Ramp.
6	Remove the Rear Cover.
7	Remove the two screws (130971) that secure the Print Circuit Board to the two
	Standoff screws (140047).
8	Remove the screws that hold the Main Board Brackets in place.
9	Use the thumb and index fingers of both hands to carefully pry the Print Circuit
	Board from the Power Circuit Board.
10	Open the Upper Imaging Assembly.
11	Remove the top two corner screws (130987) found just behind the top edge of
	the Front Cover.
12	Close the Upper Imaging Assembly.
13	Remove the screw (130987) by the Card Exit Ramp.
14	Remove the Front Cover

Continued on the next page

Persona￿ C16 Card Printer Service Manual (Rev. 5.0) 187