FARGO electronic C16 service manual Follow these steps to install the new parts

RESTRICTED USE ONLY Fargo Electronics, Inc.

Removing and replacing the Idler Springs on the C11 Card Printers without the Magnetic Encoder and for all C16 Card Printers (continued)

Step	Procedure
5	Follow these steps to install the new parts:
	a.	Install two (2) spacers (D810050). (Note: Install one (1) spacer on each
		set of posts.)
	b.	Install one (1) roller.
		Caution: If there was a black Roller, ensure that the black Roller
	was installed to the location closest to the input of the Printer.
	c.	Install one (1) Idler Spring (D830068) on top of each Roller (with the tabs
		down).
		Caution: When installing the springs, ensure that the Spring is
	centered about the centerplate tabs. This ensures that the tabs do not
	interfere with the spring.
	d.	Fasten four (4) screws (F000170) with four (4) washers (140040) into each
		Post.
		Caution: Do not over-tighten the screws.
6	Replace the bottom access cover and fasten the two (2) screws.
7	Turn the Printer upright.

Persona￿ C16 Card Printer Service Manual (Rev. 5.0) 196