RESTRICTED USE ONLY | Fargo Electronics, Inc. |
Replacing the Printhead Harness Assembly (830162-00)
Refer to Drawing 830119-XX
Estimated Repair Time: 30 minutes.
Note: The Printhead Harness Assembly includes the following cables: Data and Power Bus cables for the Printhead, Cooling Fan, Ribbon Sensor Board Assembly and the Headlift Sensor Switch.
Steps | Procedure |
|
|
1 |
|
| Caution: Turn off the Printer and unplug the power cord from the |
| Printer. |
|
|
2 | Open the Upper Imaging Assembly. |
|
|
3 | Unscrew the two Thumbscrews (130887). |
|
|
4 | Remove the Head Cover Plate (820253). |
|
|
5 | Raise the tip of the Head Spring (810214) about ¼ |
| Assembly (820199). |
|
|
6 | Remove the spacer from the top of the Printhead Assembly. |
|
|
7 | Grasp the two plastic forks on each side of the Printhead Assembly, pivot them |
| upward and release the Head Spring. |
|
|
8 | Disconnect the two cables from the printhead. |
|
|
9 | Loosen the top two corner screws (130987) found just behind the top edge of |
| the Rear Cover. |
|
|
10 | Close the Upper Imaging Assembly. |
|
|
11 | Remove the screw (130987) by the Card Exit Ramp. |
|
|
12 | Remove the Rear Cover. |
|
|
13 | Remove the two screws (130971) that secure the Print Circuit Board to the two |
| Standoff screws (140047). |
|
|
14 | Remove the screws that hold the Main Board Brackets in place. |
|
|
Continued on the next page
Persona C16 Card Printer Service Manual (Rev. 5.0) | 167 |